Cleaning or Replacing the Filters NP600 Portable Projector

The air-filter sponge keeps dust and dirt from getting inside the projector and should be frequently cleaned. If the filter is dirty or clogged, your projector may overheat.

NOTE: The message for filter cleaning will be displayed for one minute after the projector is turned on or off. To cancel the message, press any button on the projector cabinet or the remote control.

CAUTION

• Turn off the projector, turn off the main power switch and unplug the projector before replacing the filters.
• Only clean the outside of the filter cover with a vacuum cleaner.
• Do not attempt to operate the projector without the filter cover.

To clean the a_r-filter:
Vacuum the filter-through the filter cover.

To replace the filter (sponge):

1. Remove the filter cover (2 locations) by pushing up on the catch of the cover until you feel it detach.
2. Replace two filters.
   (1) Gently peel off the filter (sponge) and clean the filter cover.
   (2) Attach the new filter to the filter cover.
3. Reinstall the new filter cover (2 locations).• Inser t the filter cover until you feel click.
4. Clear the filter hours used.

To reset the filter usage time, from the menu, select [RESET] -> [CLEAR FILTER HOURS].

NOTE: Do not wash the filter with soap and water. Soap and water will damage the filter membrane. Before replacing the filter, remove dust and dirt from the projector cabinet. Keep out dust and dirt during filter replacement.

NOTE: When you replace the lamp, it is also wise to replace the filter. The filter comes in the same package with your replacement lamp.